22 X 40 Watt Power Amp- NEW!
This power amp is compatible with the TBS-5 and is used in all of our vehicle setups. Designed for a 12V system, it comes with in a shrink tubing for easy installation. Actual power output may vary considerably based on speaker rating, suze and arrangement. ( 2Ohm, 10% THD)
BAMP40 $ 95.00 USD
Benedini Smoke Module- NEW!
This is the latest generation smoke module used in all Spearhead Armor tanks, and uses water, not oil! This is to be used in conjunction with the TBS5 and TBS 5 Light II modules. The smoke is proportional to the engine speed providing greater realism and effect.
Pictured here is the device which creates water vapor. This system allows the modeler a lot more freedom in designing a water reservoir with larger capacity thus eleminating the hassle of frequent refills.
SMOKE $ 255.00 USD
Live Action Animatronic Controller-NEW!
We have been very fortunate in finding an electronic engineer who has allowed us to upgrade our line of animatronic figures and servo actuated MG's. The controller pictured to the left was designed by Frank P. and can power up to six separate channels or servos at one time. With LED lights, easy hookups and very compact size, this programmable controller has allowed us to do more with less.
Contact us for more information.
Smoker by Wiggtronics-NEW!
We are really excited about this new smoker unit from Wiggytronics. Utilizing an ultrasonic mister and fan unit linked to a Benedini mister, this smoker produces the most smoke of any product we have witnessed thus far.
When used in conjunction with the Benedini control chip, the smoke is proportional to the amount of throttle that is given. A characteristic "belch" is even included when the vehicle is first started. This are sold with, or without the Benedini Smoke Module.
WIGSMOKE w/o Benedini $ 120.00 USD
WIGSMOKEC w/Benedini 320.00 USD
Benedini control board 200.00 USD
(does not incl. mister)
Control Box for 12/24 volt tanks
This latest addition to our product line is a long time coming. A properly formatted control box takes the guess work out of your electrical system wiring and charging chores. These are available for both 12 and 24 volt systems and can be used with a charging port (not incl.) for greater ease and faster charges.
The control box provides top mounted fuse links, battery status monitor, a 7 prong plug for turret wiring and receiver battery monitor for those of you who do not use BEC.
These control boxes can be comfortably mounted in the rear of the Panzer IV/JPIV or situated near rear engine hatches for easy access on the Tiger, Panther and King Tiger.
Specs:
12 Volt: 150mm X 105mm X 75mm
24 Volt: 175mm X 125mm X 105mm
WIGBOX12 $ 245.00 USD
WIGBOX24 $ 315.00 USD
This item is currently unavailable
Charging Modules for 12/24 Volt Tanks
This module great simplifies recharging of your 12/24 volt tank. Module mounts inside of hull permitting easy access and you dont have to remove the batteries for charging.
WIGCHARG $ 55.00 USD
Electronize 30 Amp Microprocessor Speed Controller- NEW!
We use these exclusively in our project builds on any tank with a 12volt operating system. They have proven relability and are far less expensive than the 4QD's. These are the ESC's of choice for our radio control conversion kits for the Battle Ready Armor series.
Standard radio control servo signal input. (standard connector supplied)
Smooth P.W.M. forward and reverse speed control.
Selectable operating mode.
Low frequency mode: 100Hz
Variable frequency mode: 10 to 1000Hz
High frequency mode: 2000Hz
Low loss Power MOSFET current switching. (Only 2.7 milli-Ohms)
Low loss heavy duty cables. (0.25mm2)
High current automotive relays designed specifically for high power motor control.
Precision pre-set neutral.
Adjustable speed range to match throttle stick travel or scale speed.
6 to 24 volt motor battery operation. (5.5 volt min.)
30 amp. continuous load rating in either direction.
90 amp. short term stall rating. (continuous MOSFET rating)*
540 amp. peak rating.
ELECT30 $ 125.00 USD
